What are the current problems?
|Goods-related||» Loss of goods (goods not where they should be)|
» Damage to goods (stacked goods collapsing, falling, colliding with forklifts, etc.)
» Goods placed in prohibited areas such as passages or emergency exits
|Accidents and problems||» Collisions between forklifts and other forklifts, people or goods|
» Damage to equipment
» Problems and stops in logistics sorting line
|System management||» Management of each distribution site is handled separately and not centralized|
» High-resolution data is stored, enlarging data size and shortening data retention period
» Takes time to find video of problems that occurred
|Others||» Cannot monitor warehouse or detect changes when lights are turned off at night|
» Difficult to balance monitoring/management of employees and suppliers while considering their privacy
» Cannot assign a person to constantly monitor video
» Even if a problem occurs, it takes a long time to be discovered
|Existing analog equipment||» Poor camera quality, meaning the situation cannot be accurately determined|
» Narrow angle of view, and many blind spots even when a large number of cameras are installed
» Information other than images cannot be obtained
» Problems cannot be detected unless the video is constantly watched
» Takes time to find video at the time of trouble
❱ Monitor without blind spots and record problems that occur
❱ Manage people entering and exiting warehouse by video (in addition to entry and exit system that uses cards)
❱ Monitor in low-light environments such as when lights are turned off at night
❱ Multi-site monitoring with a network
❱ Product lineup for both indoor and outdoor installation
❱ Camera recognizes occurrence of problems and notifies the administrator
❱ One-stop solutions including cameras, recorders, and management software
❱ Provide people/forklifts flow line and heat map information to assist in making efficient placement decisions
Available modes include Fisheye, Double Panorama, Panorama, Quad PTZ, and 4-stream, and the camera can output video images based on the selected video mode for reduced loads on the viewing system.
Even in dark locations, color images with low noise can be reproduced to clearly view the movement of people. This is effective for not only parts of the warehouse that are constantly dim, but also normal locations after the lights are turned off.
In locations where it is bright during the day but dark at night, the camera can automatically determine the brightness of the area and record video under the optimum conditions.
During nighttime hours, the camera automatically switches to black-and-white video for providing footage with high visibility.
Cameras with an IR LED can be used to monitor environments that are completely dark. This enables areas without the level of illumination required to be monitored to detect intruders.
The IR LED can illuminate a wide area so that monitoring is not limited to a specific part of the image.
The built-in IR LED can capture subjects up to 30 meters away. The lens design also has a wide angle of view to allow monitoring over a wide area.
Moving areas that must be monitored are captured at high resolution, and areas where the video remains unchanged
are captured at low resolution for reducing the total amount of image data.
Up to eight locations can be specified as high-resolution monitoring areas.
Locations such as loading sites and sorting lines can be checked in real time even when moving to the warehouse from the office by using a tablet PC or smartphone.
Also, you can check video data stored on the recorder or an SD memory card installed in the camera.
If problems occur, you can look at the video and check on the situation even when away from the actual location.
With a combination of a 360-degree Network Microphone and a 360-degree Network Camera, the audio of a specific location in the video can be heard by itself.
For example, a single 360-degree Network Microphone with 360-degree Network Camera can be installed on the ceiling, enabling the separate conversations at each area to be heard in detail.
This enables the cause to be immediately identified when a problem occurs.
Normal fixed lens cameras can only monitor a certain direction, but the lens of a PTZ camera can be operated remotely to switch to the direction you want to view. Detailed areas can also be zoomed in to a maximum of 90x. Since the cameras can be infinitely rotated 360-degree at a high speed of 300 degrees/sec, you will not miss the subjects you want to monitor.
Preset Sequences --------------------------------------------------------------------
If the locations you want to monitor are fixed, you can register them in advance to move to them with a single touch or automatically patrol the registered locations. Data can be saved to a recorder by automatically patrolling the registered locations, without intervention by an operator.
Ranges that cannot be covered with a single fixed lens camera can be covered by patrolling.
In our Rain-wash coated models, a special coating is applied so that water droplets are repelled allowing clear images to be recorded even during rainfall.
This coating is also effective at repelling dirt so that cleaning of the dome cover is required less frequently.
* WV-SFV781L / WV-SPV781L / WV-SW598A
When installed in locations that are prone to vandalism and tampering, measures are required for preventing damage to the camera.
Models featuring the Vandal Resistant mechanism are ideal for installation in these types of locations.
Waterproofing and dustproofing function compliant with IP66.
Can be installed outside in an area that receives direct wind and rain without special housing. Compliant with IP66 (IEC60529)
The MOR (Moving Object Removal)*1 function masks moving objects, and lets you black out areas that you definitely want to conceal. In contrast, you can remove the MOR function for areas you want to monitor with high precision. In addition, you can protect privacy in scenes that you want to monitor, allowing the monitored area to be captured while protecting the privacy of employees.
This provides visualization of the traffic patterns by people and how long they stay in one place. For example, you can analyze the movements of employees and forklifts and consider repositioning objects and passages to make it easier to perform work.
H.264 codec is comprised of I-Frame, which records all video information, and other frames that depict the difference. Although information encoded at regular
intervals with I-Frame is necessary, collecting all the data will increase the size of the data file.
While maintaining smooth, high quality video, Smart Coding reduces the size of the file by cropping the motionless I-frame scenes. Reducing the size of the
data file extends the recording duration and reduces the load on the network.
The camera itself features intelligent functionality for notifying the administrator about changes to situations or dangers using a variety of methods. This eliminates the need to constantly watch the screen in the control room for reducing the TCO.
*1 Extension software(optional) is required.
- the motion of objects in the viewing or detection area.
Frames and tracks are displayed around the detected moving object in the live image. Up to 8 objects can be detected simultaneously.